MEMS based monolithic Phased array using 3-bit Switched-line Phase Shifter
Main Article Content
Abstract
This article details the design of an electronically scanning phased array antenna with proposed fabrication process steps. Structure is based upon RF micro-electromechanical system (MEMS) technology. Capacitive type shunt switches have been implemented here to cater high frequency operation. The architecture, which is deigned at 30 GHz, consists of 3-bit (11.25º, 22.5º and 45º) integrated Switched-line phase shifter and a linearly polarized microstrip patch antenna. Detailed design tricks of the Ka-band phase shifter is outlined here. The whole design is targeted for future monolithic integration. So, the substrate of choice is High Resistive Silicon (ρ > 8kΩ-cm, tan δ =0.01 and ϵr =11.8). The overall circuit occupies an cross-sectional area of 20 × 5 mm2. The simulated results show that the phase shifter can provide nearly 11.25º/22.5º/45º phase shifts and their combinations at the expense of 1dB average insertion loss at 30 GHz for eight combinations. Practical fabrication process flow using surface micromachining is proposed here. Critical dimensions of the phased array structure is governed by the deign rules of the standard CMOS/MEMS foundry.
Downloads
Article Details
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
References
G. M. Rebeiz, RF MEMS Theory, Design, and Technology, Hoboken,NJ: Wiley, 2003.
B. R. Norvell, R. J. Hancock, J. K. Smith, M. I. Pugh, S. W. Theis, and J. Kviakofsky, Micro electro mechanical switch (MEMS) technology applied to electronically scanned arrays for space based radar, Proc.Aerosp. Conf., pp. 239–2471999.
K.Topalli, O.A. Civi, S.Demir, S.Koc and T.Akin, A monolithic phased array using 3-bit distributed RF MEMS phase shifters, IEEE Transactions on MTT 56(2): 270-277,2008.
R. J. Mailloux, Phased Array Antenna Handbook. Norwood, MA: Artech House, 1994.
D. Parker and D. C. Zimmermann, Phased arrays—Part II: Implementations,applications, and future trends, IEEE Trans. MTT-50(3),pp. 688–698, 2002.
K. Van Caekenberghe, T. Vaha-Heikkila, G. Rebeiz, and K. Sarabandi, Ka-band MEMS TTD passive electronically scanned array (ESA), IEEE Antennas Propag. Symp. Dig., pp. 513–516, 2006.
K. Topalli, M. Unlu, O. A. Civi, S. Demir, S. Koc, and T. Akin, A monolithic phased array using 3-bit DMTL RF MEMS phase shifters, IEEE Antennas Propag. Symp. Dig., pp. 517–520, 2006.
W. E. Hord, C. R. Boyd, Jr., and D. Diaz, A new type of fast switching dual-mode ferrite phase shifter, IEEE MTT-S Int. Microw. Symp. Dig., vol. II, pp. 985–988, 1987.
C. R. Boyd, An accurate analog ferrite phase shifter, IEEE MTT-S Int. Microw. Symp. Dig., pp. 104–105, 1971.
V. Sokolov, J. J. Geddes, A. Contolatis, P. E. Bauhahn, and C. Chao, A Ka-band GaAs monolithic phase shifter, IEEE Trans. Microw. Theory Tech., 31(12), pp. 1077–1083,1983.
S.Koul and B.Bhat, Microwave and Millimeter Wave Phase Shifters: Semiconductor and Delay Line Phase Shifters, Artech House Publishers,1992.
C.A.Balanis, Antenna Theory: Analysis and Design, New York: Harper and Row, 1997.